My Binding Standard APC45 Programmable Manual de instrucciones descargar pdf (Pagina 45)

Knife Angle Adjustment Replacement and Adjustment

4-2 Knife Angle Adjustment

Fasten the lock screw.

Close the window for adjustment.

- Fasten the mounting screw.

Turn on the power switch.

- The indication [LOWER KNIFE] is shown on

the guide window.

Press the cutting buttons.

- The indication [FIX KNIFE] is shown in the

guide window.

Lift the knife holder and the clamp.

- Press one of the cutting buttons first, and then

press another cutting button after 0.5 seconds

or later.

- The knife holder and the clamp lifts and stops.

Install the knife cover and press the

button.

Perform the test cutting.

- Place wide sheets and check that the sheets

do not remain uncut. If the sheets still remain

uncut, repeat the steps through .

- If only bottom sheets remain uncut, the prob-

lem can be improved also by lowering the

knife position. Refer to “4-1 Knife Lower Limit

Adjustment.”

Allen Wrench

4 mm

(0.16”)

Lock

Screw

(Inside)

Opening

Mounting

Screw

OFF

LOWER KNIFE

FIX KNIFE

Cutting Buttons

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 53 54

Sin comentarios

My Binding Standard APC45 Programmable Manual de instrucciones Pagina 45